Minuteman-ups Enterprise Plus Series Bedienungsanleitung Seite 1

User's ManualEnterprise PlusSeries UPS

9EnglishINSTALLATION PLACEMENTThis UPS series is intended to be install in a temperature controlled environ-ment that is free of conductive contaminan

10EnglishCONNECTING THE BATTERIES(QUALIFIED SERVICE PERSONNEL ONLY)Please read all of the WARNINGS and CAUTIONS before attempting to con-nect the batt

11EnglishRACKMOUNT CONFIGURATIONThis UPS comes with mounting brackets for the standard 19" (46.5cm) rack.The mounting brackets to fit a 23"

12EnglishTOWER CONFIGURATIONThe tower configuration allows the user to install the UPS in the up-right positionnext to the tower computer. The tower

13EnglishWALLMOUNT CONFIGURATIONThe wallmount configuration allows the user to mount the UPS on the wall. There isa wallmount bracket kit available f

14EnglishCHARGING THE BATTERYThe UPS will charge the internal batteries whenever the UPS is connected toan AC source and there is an acceptable AC vol

15EnglishSYSTEM OVERVIEWThis Line-Interactive UPS protects computers, internetworking, and telecom-munications equipment from blackouts, brownouts, ov

16EnglishCOMMUNICATIONS PORTS (RS232 and USB)The RS232 communication port is a standard DB9 female with both RS232 andsimulated contact closure capabi

17EnglishWEAK/BAD BATTERYThe UPS automatically tests the battery’s condition and will illuminate the Weak/Bad Battery LED and sound the alarm. This a

18EnglishPossible CauseSymptomWhat To DoPress and release the On/Off/Test button to start UPSOn/Off/Test button notpushedUPS will not turn onReset cir

1© Copyright 20061. Introduction 22. Controls and Indicators 63. Installation 94. Operation 155. Troubleshooting 186. Replacing the Battery 197. Obta

19EnglishREPLACING THE BATTERYWARNING!This Uninterruptible Power Supply contains potentially hazardousvoltages. Do not attempt to disassemble the UPS

20EnglishBATTERY REPLACEMENT PROCEDUREPLEASE READ THE CAUTIONS AND WARNINGS BEFORE ATTEMPTINGTO REPLACE THE BATTERIESHot-swappable batteries mean that

21English8. Remove the two retaining screws for the battery retaining bracket. (FIG. 3)9. Remove the battery retaining bracket. (FIG. 3)10. Disconn

22EnglishIF THE UPS REQUIRES SERVICE1. Use the TROUBLESHOOTING section to eliminate obvious causes.2. Verify there are no circuit breakers tripped. A

23EnglishDefault: 120VAC (208VAC), User selectable: 127VAC (240VAC)750VA600W1500VA1200W1000VA800WProtectionWaveform TypeOver-Current, Short-Circuit Pr

24EnglishBATTERY SYSTEMTypical Recharge TimeTypical Battery LifeBattery: Quantity/Rating3-5 years, depending on discharge cycles and ambient temp3-12V

25English(These items may require optional software or hardware)FunctionFactoryDefaultDescriptionUser ChoicesSetinverteroutputvoltageShut-downTypeSeta

26EnglishPara Systems Inc. (Para Systems) warrants this equipment, when properlyapplied and operated within specified conditions, against faulty mater

27EnglishEXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL PARA SYSTEMS BELIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUEN-TIAL DAMAGES ARISING

28EnglishA1. DECLARATION OF CONFORMITYApplication of Council Directive(s): 89/336/EEC, 73/23/EECStandard(s) to which Conformity is declared:Manufactu

2IMPORTANT SAFETY INSTRUCTIONSSAVE THESE INSTRUCTIONS !EnglishThank you for purchasing this power protection product. It has been designedand manufac

29Notes:English

30EnglishNotes:

Para Systems, Inc.1455 Lemay Dr.Carrollton, TX 75007Phone: 1-972-446-7363Fax: 1-972-446-9011Internet: minutemanups.comUPS Sizing: sizemyups.comPN - 3

3WARNING: Risk of Electrical Shock. Hazardous live parts insidethese power supplies are energized from the battery even when theAC input is disconne

4EnglishAfter removing your UPS from its carton, it should be inspected for damage thatmay have occurred in shipping. Immediately notify the carrier

5EnglishLife Support PolicyAs a general policy, we do not recommend the use of any of our products in lifesupport applications where failure or malfun

6EnglishThe AC normal (green) LED illuminates in a steady state when theUPS is on and operating in the AC normal mode. The AC normalLED will extingui

7EnglishThe Load Level Bar Graph (AC mode only) operates as follows:LED #10: >10% load (green/red/yellow) LED will be green and illu-minated when t

8EnglishREAR PANEL1. The RS232 Communications Interface Port is for UPS monitoring and control.2. The USB Communications Interface Port is for UPS m